Description
Hood Stop Support Rubber Bumper for Jeep Wrangler JK 2007-2017 — 2-Pack
Replace your worn, cracked, or missing hood stop bumpers on your 2007-2017 Jeep Wrangler JK with this OEM-grade 2-pack. These rubber bumpers thread into the factory mounting holes on the radiator support and provide proper hood alignment, eliminate hood flutter at highway speeds, and prevent metal-on-metal contact between the hood and front grille. If your JK's hood has been rattling or sitting unevenly, these affordable bumpers are the fix.
Key Features
-
OEM-Grade EPDM Rubber: Manufactured from durable EPDM rubber that matches or exceeds factory specifications — resistant to UV, ozone, extreme temperatures, and chemicals
-
Adjustable Hood Height: Threaded stud design allows you to adjust hood panel gap and alignment by simply turning the bumper in or out
-
Eliminates Hood Rattle: Worn factory bumpers allow the hood to vibrate against the latch at highway speeds — new bumpers restore proper tension and eliminate noise
-
Screw-In Installation: Simply unscrew the old bumpers (if still present) and thread in the new ones by hand — no tools required for a basic swap
-
2-Pack Value: Includes both left and right side bumpers — replace both at the same time for even hood alignment
Compatibility
| Year |
Make |
Model |
Notes |
| 2007-2017 |
Jeep |
Wrangler JK (2-Door) |
All trim levels |
| 2007-2017 |
Jeep |
Wrangler JKU (4-Door) |
All trim levels |
Note: Not compatible with 2018+ JL/JLU models (different hood bumper design). Not compatible with TJ (1997-2006) or YJ (1987-1995) models.
Signs You Need New Hood Bumpers
- Hood visibly shakes or vibrates at highway speeds (50+ MPH)
- Uneven hood alignment — one side sits lower than the other
- Rubber bumpers are cracked, flattened, or completely missing
- Hood latch requires excessive force to close
- Wind noise or whistling from the front of the hood
Frequently Asked Questions
Q: Will these stop my hood flutter at 70 MPH?
A: Yes, worn hood bumpers are the #1 cause of JK hood flutter. These new EPDM rubber bumpers provide the proper tension against the hood to eliminate vibration. If flutter persists after replacement, also check your hood latches — worn latches combined with worn bumpers create the flutter condition.
Q: How do I adjust the hood height?
A: Turn the bumper clockwise to lower the hood (reduces gap) or counter-clockwise to raise it (increases gap). Make small 1/4-turn adjustments and test the hood closure after each adjustment. The hood should close firmly but not require excessive force.
Q: Is this the same part the dealer sells?
A: These bumpers are manufactured to the same specifications as the Mopar OEM part (55397232AB) but at a fraction of the dealer price. Same fit, same function, better value with the 2-pack.
Q: Do I need any special tools?
A: No tools required. The factory bumpers unscrew by hand (use pliers with a rag if they're stubborn). New bumpers thread in by hand — tighten until snug, then adjust for proper hood alignment.
